The unfortunate part is that once you??™ve set
this parameter in the wizard, you can??™t change it through any method on the
OCS administrative console. You can??™t even change it by rerunning the setup!
I recommend that you use the command-line utility lcscmd.exe for this purpose.
Configuring the Edge Server ??? Chapter 5 171
A successful Telnet connection will show a blank screen with a blinking cursor. An
unsuccessful Telnet connection will look like Figure 5.31.
Figure 5.31 Failed Telnet Connection
However, if you are able to telnet to your Edge Server on port 443, it is likely that the
Edge Server is unable to pass the authentication through to your front-end server or directors.
Run the Edge Server Validation Wizard to make sure it makes all the proper connections
back to the front-end server.
If the Validation Wizard comes back with no errors, run the Front End Server Validation
Wizard to make sure it can connect to the Edge Server.
TIP
Windows Vista no longer enables the Telnet client by default. To enable the
client, go to the Control Panel and click on Programs and Features. Click on
the link for Turn Windows Features On or Off. Check the box next to Telnet
Client and click OK.
172 Chapter 5 ??? Confi guring the Edge Server
If all else fails, don??™t forget to use the Windows event logs. The application log and the
OCS log provide lots of good information about any errors that occur. Check both the Edge
Server event logs as well as those on the front-end server.
Pages:
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223